Search Results for ‘foxbody 5.0’

My hood flew open while I was driving my 92 Mustang GT. I replaced the hinges and bought a new cowl grille, but now the hood lifts up the cowl grille when I try opening the hood. I've adjusted the hood several times but I'm thinking I just need a new hood. Any thoughts or suggestions?

Do not know much about the car other than what I see, 3 bar gt40 heads, tubular gt40 intake, stock tb, 19lb injectors. Not sure of cam or rr as I haven’t popped a valve cover off yet but it is not a stock cam. Car has a idle surge I replaced the iac and tps is good I believe it was .965 Now to...

Hello everyone.. So I have a SCT BDX tuner and im wondering if any of you have used a BDX to tune a coyote swap car. Specifically does this device work with the Gen II ford performance control pack. I have heard there may be some issues with it... Can anyone attest to this?

I'm selling my 87 Ford Mustang GT Convertible. I have owned the car for for 22 years and now selling because I have too many toys and one has to go. The car has been garage kept and driven less than 3K in the last five years. I love this car and would love to keep it, but I just don't drive it...

Hi! I have a 1989 Mustang GT that's running lean. There's no check engine light while driving but after testing for codes I got a "41" and "181". It has a bit of a loss of power and tends to stall and stops. I've done lots of work to the car including new plugs, cap and rotor, TPS, O2 sensors...

Just recently purchased a bar find. 26k miles. It's been sitting for an estimated 15 years. I obviously have a ton of work down the road as it needs, tires, shocks, etc.. However, I'm in the early stages and can't get the thing to run right. It is running extremely rich and surging. It sounds as...

Hey guys , Looking for some help . I did a battery relocation on my fox . I used 1/0 welding cable and I want to put in a inline fuse. I'm not really sure what size Fuze I should go with . I have dual electric fans that are 42 amps combined and I have a 130 amp alternator . I do have some other...

Hello all, hope this is in the correct forum. I've been having some issues for the past year on tracking down an issue on my 1990 Mustang 5.0. This consists of Check Engine lights at certain RPM's, steering wheel and general chassis shake in all 5 gears. I want to try to keep this short and...

I just got a bare 60mm throttle body and I was told to switch out the butterfly and so on and it should work so my question is will my stock parts work in the 60mm

Hello I have a 1991 mustang 5.0 and I have a voltege problem. When the car is running the voltage is good. But right when I turn it off the voltage is low and when I try to start it the starter hesitates. I just replaced the battery with a new one and it’s still happening it has a 3g alternator...

so I got a throttle body yesterday I was told it was a 60 mm throttle body but looking at it seems like it came off a 5 speed it has 2 nipples on it 1 for throttle cable but on my automatic it has 1 nipple then a hole for the kickdown cable can I even use the throttle body I got it's used and...

New to tuning and trying to get a solid E85 base tune on my terminator x for my turbo Foxbody. Can anybody help?

Yo need some insight on a issue my fox has had for a bit. When I cold start I have a rough/surging idle until it fully warm ups. To find the issue I would unplug sensors one by one and if there was a change without it plugged in I assumed it was working when plugged in. When I unplug the maf no...

Hey guys , So I changed my oil yesterday and it smelled like straight fuel and felt thinner. I have noticed that it would smoked alittle on start up but would clear within couple mins . Also if I shut it off and tried starting the car up again I would have to hold the throttle wide open and let...

Hey guys, So im looking into converting my t5 to a aod . Gots me a couple questions cause I'm not really to sure about couple things here. To start I have a 89 lx . Has a 302 with a 90mm maf 60 injectors b303 cam and a vortech charger at 15 psi . Sct tuner . With 3.73 gear . Car made 509 on...

New to the Fox Body scene and want to keep everything on my GT that I just bought this last year period-correct, no modern tech, nothing on it can be 2000’s+ 1999 and under. With that said, anyone know of or run some good suspension combos back in the day? Also wondering if the Strange 10-way...