Ford Mustang Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 58 Results
  1. General Mustang Tech
    I just finished a 4cyl to 8cyl swap. The car came with an ECM that I am not using because I have my 8cyl ECM in. My question is, will the ECM that came with the car work for a V8 application? also, what years will the ECM work on? Its for a 1991. I’m just looking to sell it and see if its...
  2. Superchargers
    I will soon enough be done my M112 Supercharged intercooled 5.0 and needed some info on ECU. The car is a 92 tbird 5.0, I am thinking of transitioning to the 96-2001 explorer coil on plug with cam and crank sensor. (Mainly for supercharger clearance) I was also thinking of getting a bigger MAF...
  3. Sold T4M0

    Electronics and Entertainment
    1994-1995 FORD MUSTANG GT 5.0L MT ECU PCM F4ZF-12A650-EA T4M0
    $100 USD
  4. 93-95 Lightning
    I have a 94 lightning that has been thrown around between some family friends and have just recently acquired it after I graduated high school, it’s almost undriveable with the speed density system as the previous owner installed a cam, I need help looking for a mass air conversion kit or...
  5. Electrical & Wiring
    Picked up a new negative battery cable at the local auto parts store instead of paying the nearly $70.00 on LMR for the battery cable kit, however there is one problem i did run into. When taking a look at the small wire that splits from the negative battery cable from LMR, I see that it...
  6. For Sale A9L ECU

    Electronics and Entertainment
    Got an extra ECU laying around. Used to have a tuner on it so the post is cleaned off already. Shipping will run $15
    $200 USD
  7. 94/95 Tech
    Hey guys, I have a 95 gt I just built about a month ago. It’s got cobra intake manifold, gt40p heads, a Ford B cam, new pushrods, rockers, and lifters, BBK 70mm throttle body, cold air intake with stock MAF and stock injectors (3 replacements) and a bama tuner. Before I built it it was...
  8. GT & SOHC
    Just got brand new engine installed and plugged in. Fired it up and ran fine for about 5 minutes, the RPMs dropped extremely slow when I touched the throttle. Then after about 10 minutes the "check engine" light came on. I tried plugging in my code reader and all it said was that there was an...
  9. Electronics and Entertainment
    Multiple mass air Foxbody ECUs for auto and manual trans. $265 shipped and PayPal.
  10. EEC Tech
    Hello All, I just wanted to post this here for anyone experiencing the same problems I had with a new 1992 5.0 5spd Mustang LX Hatchback me and my wife just bought to restore. Issues: No injector pulse (injectors would not fire), engine would not run except for starting fluid being sprayed in...
  11. Modular Engine Parts
    I have a new (never installed or used) Megasquirt MS230-C, this is a Megasquirt 2 ECU with PCB3.0. Firmware is v2.687. Also comes with 8' Megasquirt wiring harness and DB9 tuning cable. $400 for everything. Thanks Wade
  12. Electronics and Entertainment
    FAST Classic Sequential ECU EFI kit. I had no issues with it. Complete with main harness and all sensors (NTK wideband, air, coolant, 3 bar MAP, new TPS). Harness connectors are labeled for a hassle free install. Everything (except 12v, ground wiring, and points wire) plugs right up with the...
  13. Electronics and Entertainment
    Looking for an A9P ECU for a engine swap. Thanks.
  14. Electronics and Entertainment
    I have a AEM 30-1401 EMS it's a plug and play system for 94-95 mustangs specific, comes with original box and install Cd and the needed USB to Serial cable by belkin. $450 shipped in the US! Taking out the car this weekend Message me or email me directly [email protected] will be going up on...
  15. S197 Mustang GT (2011-2014)
    Hi guys, I've just installed a 2014 engine into my 2011 GT and I think my ECU has a tune on it, only worked it out when it would only run with a big JLT intake and wont run with a stock one. I want to retune the ECU to a tune that I know and trust. Now with that, can I just flash the ECU...
  16. S197 Mustang GT (2011-2014)
    Hi guys, I am in the UK and have a 2011 Mustang GT. I've just installed a late 2014 crate engine (guessing late 14 by the different dipstick) into it as the last one died. However, we cant get the crank sensors to relearn and we've tried everything, revving it higher, taking it for a drive...
  17. Electronics and Entertainment
    A9L $103 Shipped w/ pp fees included I had a Tweecer R/t mated to it and never had any issues with it Can ship same day depending when paid I also have a Tweecer r/t I'll sell but just need to find the cable for it
  18. 5.0/5.8 Engine Tech
    Putting my mustang motor project into a ranger now. It has 4wd and I want to keep it that way. Will an explorer computer and wire harness work with a mustang motor? if so what needs to be adapted, if not what can I do instead? Thanks for any info here I know this is not all about mustangs so...
  19. Windsor Engine Parts
    I am doing a Mass air conversion on my 5.0 Thunderbird and need items to complete it. I need an A9P computer and wiring harness. Let me know what you got! Automatic Cars (Calibration code A9P): E9ZZ-12A650-CA E9ZF-12A650-CA F3ZF-12A650-BA See more at: COOL CATS » Celebrating the 1983-88...
1-20 of 58 Results