Ford Mustang Forums banner
clearance
1-11 of 11 Results
  1. 5.0/5.8 Engine Tech
    Does anyone know if I'm asking for trouble by replacing my crane 2031 with an e303 cam? It's been almost 20 yrs since I put the setup I have in there. I remember changing the pushrods too. Just wondering if since the 2031 was set up fine and worked physically (clearances etc.) will the e303 fly...
  2. SVT & DOHC
    i have a question on checking connecting rod side clearance. I believe the procedure is to push both rods all the way to one side. And have it touch the crank. Then use a feeler gauge to measure the gap to make sure it's in spec. my question is that after that is done do the rods need to be...
  3. 94/95 Tech
    We want to find the best fitting 1.75" LTs for our 94... There are many complicating factors though, and I hope to get info from someone who has had good experiences with LTs on a car that is close to ours as possible... Fox headers preferred, but we will make SN headers work if someone has had...
  4. General Mustang Tech
    Hey.. got a 1991 LX and just got new o2 sensors and a BBK Offroad H Pipe #1507 and wondered about the oxygen sensor clearance on passenger side between o2 sensor and stock k member just wondering, the passenger side oxygen sensor fits barely, but is literlly agaonst the k member. wondered...
  5. Advertiser's Showcase
    What's up everyone? I have some clearance items that have ridiculous pricing that we're blowing out the door. These items are ONLY available here on the forum, so please only share this with friends who have login names. These all have limited quantity, but they are the deepest discounts we've...
  6. 94/95 Tech
    For a 94 GT -Just got my BBK Shorty, Equal, Ceramic-coated headers for my '94 5.0. heard from several sources that you have to get new motor mounts, or you don't need to, for header vs steering shaft rub issues Anyone installed these headers on a '94 5.0 with stock suspension? i want to hear...
  7. 5.0/5.8 Engine Tech
    My mounts on my 86 GT vert were bad, so I replaced them this weekend along with the trans mount. I had the typical fan rubbing occurring, and my fan blade was cracked at almost every vane. After putting in my new mounts, I still had some slight rubbing of the fan and wound up shimming the...
  8. 5.0/5.8 Engine Tech
    Assembling another motor, and while I was checking piston to valve clearance I came up with a problem (maybe). The intake valves I am using are the largest I have ever installed, and as such I noticed that the side clearance between the valve and the piston valve relief was very very small...
  9. 94/95 Tech
    I need to buy valve covers for my AFR 185 heads that will clear my Crane Gold 1.6 stud mount roller rockers (they are pretty big) and will still fit under my Kenne Bell with the Flowzilla pipe. This will be my first Kenne Bell install, so I'm not sure if I'm going to have clearance issues or...
  10. Wheels and Tires
    I am about to pay for a new set of older Boyds that are all 18X8, with a 5.5 backspacing, 27mm offset, they are in the 4 X 4.25 bolt pattern. I am not planning on lowering my stock 1988 GT hatchback. I am not an expert on this stuff, but if I get the right size tires, can I avoid rubbing the...
1-11 of 11 Results
Top